Page 1 of 1
SCC Revision Number
Posted: Fri Apr 22, 2005 10:35 pm
by Guest
I was wondering if I could change the default revision number 1.1 for SCC for a new file to a different number of my choice.
Posted: Fri Apr 22, 2005 11:00 pm
by jussij
If you mean SCC in general then I think not, since I can not see any way to pass this information via the SCC SccAdd function
But if you mean Zeus SCC-CVS then this might well be possible
The Zeus SCC-CVS gives CVS an SCC interface by running a CVS command lines for the different SCC functions. So the real question is what would be the CVS command line that would be use to set the revision number for a file as it is added to version control
Jussi
Posted: Sat Apr 23, 2005 4:45 pm
by Guest
I do mean the Zeus - SCC. Do you know the file I have to change in order to change the revision number??
Thanks
Posted: Mon Apr 25, 2005 11:47 am
by jussij
The current DLL can not be configured to do this
but a new version of the
Zeus SCC-CVS has been created that should fix this problem
You will need backup the original
zCvs/zCVS.dll, download the new dll from
here and replace the older dll with this new version.
Next, use the
Options, Editor Options menu and in the
Source Control panel use the
Advanced Scc Options button to bring up the
Zeus SCC-CVS configuration dialog.
Use the
About Button to make sure the version number is
1.95, then in the
Global and Command Options section edit the
Add Command Options adding
-r 1.1 for the command line. Now when a file is added to version control it will be given an initial revision number of
1.1.
Jussi